3M X62w Sicherheitsanleitung Seite 8

Important Note
1.
2. To avoid premature lamp failure, do not change the mounting position of the
�� T o avoid red�ced lamp li��e�� do not to�ch projection lamp with �are fin�ers�
. To avoid reduced image quality, do not touch projection lens or other internal
. Do not use detergents, chemicals, or any spray liquids for cleaning this unit, other
6. For maximum lamp life, do not strike or drop, improperly handle, or scratch the
7� K eep air filter clean� Re��er to the cleanin� instr�ctions contained in the "Operator's
8. Keep all ventilation openings free of any obstructions.
9. In some countries, the line voltage is N�T stable. This projector is designed to
10. Do not block intake or exhaust air vents. This will cause the projector to over heat
11.
12. To prevent damaging the projector, always hold the projector whenever using the
13. Use the accessory cable or a designated-type cable for the connection. Some
1. Make sure that you connect devices to the correct port. Incorrect connection may
1. Do not place the projector in the side/front/rear-up position, except care of the air
8
Downloaded from www.Manualslib.com
Always open the lens shutter or remove lens cap when the projection lamp is on.
projector (desktop ceiling mount or ceiling desktop mount) and continue to use the
same lamp.
optical components.
than those referred to in the "�perators Guide".
lamp glass. Also, do not install an old or used lamp.
Guide".
operate safely within a bandwidth of 100 to 120 volts / 220 to 20 volts (0 to 60
Hz) ±10%, but could fail if power drops or surges of ±10 volts occur. In these high-
risk areas, it is recommended to install a power stabilizer unit.
and shut down.
Do not place the projector in direct sunlight or near a hot object such as a heater.
elevator buttons to adjust the elevator feet.
cables have to be used with core set. A too long cable may cause certain picture
degradation. Please consult with your dealer for details. For cables that have a
core only at one end, connect the core to the projector.
result in malfunction and/or damage to the device and/or projector.
filter�
3M™ Multimedia Projector X62w Product Safety Guide
manuals search engine
© 3M 2006