Replacing Internal Clock Battery - 3M X62w Sicherheitsanleitung

Consumption of the battery makes the clock not to work correctly. When the clock is wrong or it has
stopped, please replace the battery according to the following procedures.
• To reduce the risk associated with explosion, and/or chemicals from a leaking
batteries:
-
-
-
-
-
-
-
1. Turn the projector off, and unplug the power cord. Allow the projector
to cool sufficiently.
2. After making sure that the projector has cooled adequately, slowly
turn over the projector, so that the bottom is facing.
3. Remove the battery cover.
Turn the battery cover in the direction indicated "OPEN" using such
as coins. Then the battery cover will come up. While removing the
battery cover, pick its knob.
4. Take the old battery out.
Press the metal claw of the battery holder. Then the battery will come
up. Remove the battery.
5. Put a new battery in.
Replace battery with HITACHI MAXELL, Part No.CR2032 only.
Use of another battery may present a risk of fire or explosion.
Insert a new battery in the battery holder according to its minus
terminal
by + is facing. And push the battery into the battery holder fully to
fix.
6. Close the battery cover.
Replace the battery cover in place, then turn it in the direction
indicated "CLOSE" using such as coins, to fix.
© 3M 2006
Downloaded from www.Manualslib.com

Replacing Internal Clock battery

Use only with battery type AA, CR2032 or equivalent.
�rient the battery�s plus (�) and minus (-) terminals of the batteries according to
the markings found on the remote control.
Do not leave the battery in the remote for an extended period of time.
Do not heat�� disassem�le�� short�� rechar�e�� or e�pose to fire or hi�h temperat�re�
Do not carry batteries loose in your pocket or purse.
Avoid eye and skin contact in the event that battery would leak.
Do not mix used and new batteries.
as indicated in the battery holder, so that the side marked
3M™ Multimedia Projector X62w Product Safety Guide
manuals search engine
WARNING
Battery Cover
OPEN
Knob
Metal claw
"�" marking
CLOSE
13