Inserting/Replacing The Battery; Installing Wall Holder - VOLTCRAFT DL-111K Bedienungsanleitung

11. INSERTING / REPLACING THE BATTERy
1. With a pointed object (e.g. a small screwdriver or similar), open the casing. Lever the casing off in
the direction of the arrow.
2. Pull the data logger from the casing.
3. Turn the data logger around and insert the battery into the battery compartment observing the right
polarity. Observe of the polarity markings in the battery compartment.
4. Slide the data logger back into the casing until it snaps into place. Now the data logger is ready
for programming.
12.

INSTALLING WALL HOLDER

1. Select a level, vertical surface and drill two dowel holes.
2. Insert the dowels and secure the wall bracket in vertical alignment on the surface using the screws.
The mounting holes of the wall bracket must face downwards.
3. Place the data logger in the wall bracket. The protective cap must point downwards.
Downloaded from www.Manualslib.com
Replacement of the battery is required when the red LED flashes every 20 seconds.
make sure not to damage any cables or pipes behind the wall when drilling dowel
holes.
manuals search engine
23