Before First Use; A) Protection Foil; Insert/Replace Battery - VOLTCRAFT DL-240K Bedienungsanleitung

10. Before first use

a) Protection foil

• Remove the protection foil from the LC display (4).
b) Insert/replace battery
• Install the battery before first-time use or replace the battery when the battery symbol "
display.
Removing and replacing batteries does not delete data or settings.
• Remove the protective cap from the data logger.
• Press and hold the button release battery compartment (6) and pull out the logger unit from the housing. The
housing fits tightly due to the second rubber seal (8).
• Release the button release battery compartment.
• The battery compartment is on the back of the logger unit. Insert a new and suitable battery (see "21. Technical
data" on page 57) into the battery compartment observing correct polarity (positive/+ and negative/-).
• Slide the logger unit back into the housing. Ensure that the LC display matches to the LCD window of the housing.
• Place the protective cap back onto the data logger.
The data logger performs best at room temperature. If the item is used at extremely low temperatures,
the battery life is reduced. In such case, you can reduce power consumption of the data logger in order to
prolong the operation time as following
- disable LC Display
- disable LED alarm
- set a longer sampling rate
For details refer to chapter "11. Configuration" on page 40
.
1 2
3 4
" appears in the LC
39