Interconnection Examples; 2-Channel-Mode: 1 X Stereo-System - Hifonics Zeus ZRX4002 Benutzerhandbuch

LOG0 BASS BOOST X-OVER
PROTECT
MODE
POWER BLUE / WHITE 0dB 18dB LP/BP HP FULL
ZRX4002
GND REM +12V
POWER INPUT
Loudspeaker left
2 – 8 Ohms
INTERCONNECTION
• Connect the RCA lineouts of the head unit with the RCA jacks LINE IN of the amplifier with appropriate high-value RCA cables.
• Connect the front and rear speakers with the speaker outputs (SPEAKER OUTPUT + L - and + R -).
• Always ensure that the total impedance load on the speaker outputs is not lower than 2 ohms.
Too low impedance cause high temperature and will shut down the amplifier operation.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
CROSSOVER SETTINGS
• When using bigger speakers (more than 20cm) set the X-OVER switch to the FULL position (Full Range Signal).
• When using smaller speakers (8.7cm - 16cm) set the X-OVER switch to the HP position (Highpass Mode) to avoid
any damage by lower frequencies on the speakers. The cut-off frequency is adjustable with the HP/BP controller and should
be set between 60Hz to 150Hz, depending on the size of the speakers.
• The LP Controller is not in use in this interconnecting example.
LEVEL CONTROLLER
• Turn the LEVEL controller of the amplifier to the MIN position.
• Turn the volume controller of the head unit to 80 - 90% of its full setting.
• Turn the LEVEL controller clockwise until you hear some distortion.
• Then turn back the LEVEL controller slightly until you hear a cleaner sound.
BASS BOOST CONTROLLER
• The BASS BOOST controller must be turned to 0 dB position in this interconnecting example .
BASS REMOTE
• The enclosed Bass Level Controller is not in use in this interconnecting example.
NOTE
Do not connect loudspeaker cables with the vehicle's chassis. Always ensure the correct polarity of all connections. The interchange
of plus and minus cause total loss of bass playback and could damage the speakers.
22
FUNCTIONAL INSTRUCTIONS
INTERCONNECTION EXAMPLE
LP HP/BP LEVEL
L L
30Hz 250Hz 10Hz 1.2kHz MIN MAX
INPUT

2-channel-mode: 1 x Stereo-System

AUTO TURN ON
BASS LEVEL
LEVEL
(ONLY IN HI LEVEL INPUT MODE)
CONTROLLER
OFF LOW
ON HI
R R
LINE IN LINE OUT
BRIDGED
L R
FUSE
SPEAKER OUTPUT
ZRX4002
Loudspeaker right
2 – 8 Ohms
LOG0 BASS BOOST X-OVER LP HP/BP
PROTECT
MODE
POWER BLUE / WHITE 0dB 18dB LP/BP HP FULL 30Hz 250Hz 10Hz
AUTO TURN ON
BASS LEVEL
(ONLY IN HI LEVEL INPUT MODE)
CONTROLLER
OFF
ON
ZRX4002
HP oder FULL
GND REM +12V
50A
FUSE
POWER INPUT
ZRX4002
Connect stereo RCA output (L/R) of the
head unit with LINE IN of the amplifier
LEVEL
L L
1.2kHz MIN MAX
INPUT
LEVEL
LOW
HI
R R
LINE IN LINE OUT
BRIDGED
L R
SPEAKER OUTPUT