EINHELL Bavaria BLP 100 Gebrauchsanweisung Seite 8

Anleitung BLP 100 SPK 1 neu
GB
center. Never use any tool if its switch and may cause burn marks, scorch marks
cannot be turned off and on. and - in the worst case - burn wounds and
20. Important! fires if not used without proper care.
– For your own safety, use only accesso Never dip the soldering tip into water, and
ries and attachments which are listed in never hold the soldering tip under flowing
the operating instructions or recommen water.
ded or listed by the tool manufacturer. The Wear safety goggles during soldering work.
use of any accessory or attachment other Tin and flux spatter may cause eye injuries.
than those recommended in the operating Some flux materials give off unpleasant
instructions or catalogue may involve a vapors when heated. Make sure the work
risk of injury for you personally. area is well ventilated.
21. Have repairs carried out only by a qua
lified electrician Operating instructions
– This electric tool complies with the perti
nent safety regulations. Repairs are to be Every heating phase of a maximum 12
carried out only by a qualified electrician seconds must be followed by an OFF interval
or the user may suffer an accident. of at least 48 seconds. In other words, the
22. Noise soldering gun may only be used in intermit-
– The noise level of this electric tool is tent mode.
measured in accordance with EN 50144-1. Make sure that the parts to be soldered are
Noise at the workplace may exceed 85 clean. Clean them in advance with steel wool
dB(A). In this case, the operator must or fine sanding paper.
wear ear-muffs or similar. Make sure that the soldering tip is tinned; if it
Keep these safety instructions in a safe isn't, use the supplied solder wire. Never use
place. a file to clean the soldering tip.
Wipe the soldering tip on a silicon sponge
and then tin it.
Items supplied Heat the joint and not the solder. Touch with
Soldering gun the soldering tip the parts you want to solder
2 soldering tips so that both parts are uniformly heated. Add
1 plastic tip a little tin solder to the joint.
Solder wire Withdraw the soldering gun carefully and
Plastic case quickly without moving the parts you are sol-
dering.
Use Do not use too much solder. Use only as
The soldering gun is designed for light-duty sol- much solder as necessary.
dering jobs, soldered electric connections, Take care not to overheat electric and elec-
model-making and poker-work. tronic components.
If you want to join wires together by solde-
Additional safety information ring, you should first tin their ends. Twist the
Hold the heated soldering gun only by its strands together, heat them and add a little
handle. Risk of burns! tin solder.
Put down the heated soldering gun only on The plastic tip can be used to repair objects
non-combustible and heat-resistant surfaces. made of thermoplastic material (children's
Risk of fire! toys).
The soldering tip coupling has to be secure. The standard soldering tip can be used for
Check before beginning your work. poker-work (burning motifs on wood and lea-
Keep the power cable away from the solde- ther).
ring tip at all times.
Do not stick down the ON/OFF button.
In view of the high working temperatures
involved, you should use a suitable fixture to
secure the workpiece in position.
The soldering tip becomes hot during use
8
12.02.2003 7:22 Uhr Seite 8