Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Do not operate while it is covered! At higher connected loads, the outlet strip and
the connecting cable become warm, which can lead to overheating and potentially
a fire if covered!
• Current-free only when the plug is withdrawn!
• Do not use the product when it is damaged (e.g., housing, mains cable, mains
switch). There is a risk of a life-threatening electric shock!
In this case, dispose of the product in an environmentally correct manner.
Safe operation can no longer be assumed if:
- the product shows visible signs of damage
- the product does not work at all or works poorly (leaking smoke or a smell of
burning, audible cracking noises, discolouration to the product or the adjacent
surfaces)
- the product was stored under unfavourable conditions
- it was exposed to heavy loads during transport
• Use the product only in a temperate climate, never in a tropical climate.
• Always pull the mains plug out of the mains socket before cleaning the power strip
or when the device will not be in use for a long time.
• Never pour any liquids above or next to the product. You run the risk of causing a
fire or a fatal electric shock.
However, if any liquid has entered the device, immediately disconnect the power
from the socket where the power strip is plugged in (turn off the fuse / circuit
breaker / residual current operated circuit breaker of the associated circuits). Only
then can you unplug the mains plug of the outlet strip from the mains socket and
contact a specialist. Do not use the product any longer.
• In commercial institutions, the accident prevention regulations of the Employer's
Liability Insurance Association for Electrical Systems and Operating Facilities are
to be observed!
• If you have any questions that are not answered in these operating instructions,
please contact our technical department or another specialist.
Getting started, use
Read and follow the chapter "Safety instructions" carefully.
• If required you can fasten the power strip at both ends using the two rotating mounting
brackets. Two screws are provided for each bracket.
Install the power strip only on a solid surface using suitable screws and wall plugs,
if necessary.
Make certain when drilling and tightening the screws that no cables or pipes are
damaged.
• Plug the earthed mains plug of the power strip into a regular earthed mains socket (wall
socket).
• Place the cables in such a way that nobody can trip over them.
• If you do not bolt the power strip in place, protect valuable surfaces against scratches by
using a suitable pad.
• Connect the devices to the outlets of the power strip.
• The outlets are turned on or off by pressing the large, red on/off switch ("I" = on, "O" = off).
When the adapter is switched on, a control light in the on/off switch is activated.
• When the surge protection is triggered, the green function display goes dark. In this case you
should replace the power strip against a new one, so that your devices are protected again
against overvoltage.
Maintenance and care
• The product does not require maintenance. The product contains no parts that require ser-
vicing. Therefore, do not open/dismantle it. Maintenance or repair may only be performed by
qualified personnel or a specialised repair shop.
• Switch off the outlet strip and disconnect it from the mains voltage before cleaning. Discon-
nect the earthed mains plug from the mains socket (wall socket). Also disconnect all con-
nected loads from the outlet strip.
• To clean the product, a clean, dry and soft cloth is sufficient.
• Dust can be easily removed using a clean, soft and long-bristled brush and a vacuum clean-
er.
Do not use abrasive cleaning agents, cleaning alcohol or other chemical solutions,
since these could damage the casing or even impair operation.
Disposal
Please dispose of the product at the end of its life cycle according to the applicable
statutory requirements.
Technical data
Power supply .............................................. 230 V/AC, 50 Hz
Total power rating ........................................ 3680 W (16 A)
Number of earthed sockets ......................... 6
Surge protection ......................................... yes
Leakage current ........................................... 6.5 kA
Enhanced protection against
accidental contact ........................................ yes
On/off switch ................................................ yes, 2-pole (N/L)
Cable type ................................................... H05VV-F, 3G x 1.5 mm²
Cable length ................................................ 1.5 m
Dimensions (L x W x H) ............................... 370 x 90 x 60 mm
Werbung
