Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Never pour any liquids above or next to the product. You run the risk of
causing a fire or a fatal electric shock.
However, if any liquid has entered the device, immediately disconnect the
power from the socket where the power strip is plugged in (turn off the
fuse / circuit breaker / residual current operated circuit breaker of the
associated circuits). Only then can you unplug the mains plug of the outlet
strip from the mains socket and contact a specialist. Do not use the prod-
uct any longer.
• In commercial institutions, the accident prevention regulations of the Em-
ployer's Liability Insurance Association for Electrical Systems and Operat-
ing Facilities are to be observed!
• If you have any questions that are not answered in these operating in-
structions, please contact our technical department or another specialist.
Getting started, use
Read and follow the chapter "Safety instructions" carefully.
• The power strip can be either screwed or suspended over corresponding openings
at both ends as required.
Install the power strip only on a solid surface using suitable screws and wall
plugs, if necessary.
Make certain when drilling and tightening the screws that no cables or
pipes are damaged.
• Plug the earthed mains plug of the power strip into a regular earthed mains socket
(wall socket).
• Place the outlet strip in an appropriate place. Place the cables in such a way that
nobody can trip over them. Protect valuable furniture surfaces by using a suitable
underlay to prevent scratches.
• Connect the devices to the outlets of the power strip.
• The outlets are turned on or off by pressing the large, red on/off switch ("I" = on,
"O" = off).
When the indicator light is switched on, a control light in the on/off switch is
activated.
Maintenance and care
• The product does not require maintenance. The product contains no parts that re-
quire servicing. Therefore, do not open/dismantle it. Maintenance or repair may only
be performed by qualified personnel or a specialised repair shop.
• Switch off the outlet strip and disconnect it from the mains voltage before clean-
ing. Disconnect the earthed mains plug from the mains socket (wall socket). Also
disconnect all connected loads from the outlet strip.
• To clean the product, a clean, dry and soft cloth is sufficient.
• Dust can be easily removed using a clean, soft and long-bristled brush and a vacu-
um cleaner.
Do not use abrasive cleaning agents, cleaning alcohol or other chemical
solutions, since these could damage the casing or even impair operation.
Disposal
Please dispose of the product at the end of its life cycle according to the
applicable statutory requirements.
Technical data
Item no.
1296310
Number of safety
8
outlets
Electrical connection
data
Total connected load
Child-proof lock
On/Off switch
Cable type
Cable length
Dimensions (L x W x H)
515 x 70 x 50 mm
1296311
1296312
6
3
250 V/AC, 50 Hz
max. 3680 W (16 A)
yes
yes, 2 pins (N/L)
H05VV-F, 3G x 1.5 mm²
1.5 m
430 x 70 x 50 mm
305 x 70 x 50 mm
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE.
Werbung
