LD Systems LD MIX G3 Serie Bedienungsanleitung Seite 6

9
DFX
Effect send control for input channels 1 to 4 (CH1 - CH4). The signal from the relevant channel is picked up before the volume control (post
fader) and sent to the internal effects device (DSP) according to the effect send control setting. Here, care must be taken to ensure that the
input of the effects device is not overmodulated (watch PEAK LED).
10
PRESETS
Continuous rotary knob to select one of the 16 internal digital effects. A list of all effects is to be found to the right of the controls for the
effects device (DSP).
11
DFX RET
The effects return control can be used to add the effects signal to the main signal (MAIN).
12
MUTE
Pressing the MUTE button mutes the internal effects device, causing the PEAK LED to light up continuously. Pushing the button again
cancels mute status, and the PEAK LED goes off.
13
PEAK LED
The PEAK LED lights up when the input of the internal effects device is overmodulated (reduce DFX effect send level on channels 1 to 4) and
when the internal effects device is muted (MUTE).
14
LOW
Equalizer bass band (80 Hz) for the main channel. Turn anti-clockwise to reduce the bass and clockwise to increase. In central position
(snap-in point) the equalizer is inactive.
15
MID
Equalizer mid-range band (2.5 kHz) for the main channel. Turn anti-clockwise to reduce the mid-range and clockwise to increase. In central
position (snap-in point) the equalizer is inactive.
16
HIGH
Equalizer high band (12 kHz) for the main channel. Turn anti-clockwise to reduce the treble and clockwise to increase. In central position
(snap-in point) the equalizer is inactive.
17
MAIN LEVEL
Volume control for the main channel (main volume).
18
MAIN LEVEL METER
4-segment level meter display for the main channel. When the red LED lights up, the device is operating at the distortion limit. Brief illumi-
nation at level peaks in the received signal is uncritical, but permanent illumination should be avoided by reducing the volume level.
19
POWER LED
Goes on when the device is correctly connected to the mains and switched on.
20
MONITOR
Volume control for the monitor channel. The signal is identical to the main signal and picked up before the volume control of the main
channel (MAIN LEVEL) so it can be adjusted independently.
21
MONITOR OUT
Balanced line input with a 6.3 mm jack socket. An additional active speaker can be connected. Level adjustment using the MONITOR volume
control (no. 20).
6