AWG S2 Originalbetriebsanleitung Seite 36

AWG I Operating manual I Fittings I
Replacing the protection ring on the foam tube
The protection ring is fastened with studs, which are inserted into
bores on the foam tube and additionally glued to the foam tube.
1. Lever the protection ring with studs out of the bores, and pull the
protection ring (Fig. 3/1) off the foam tube.
2. Clean the foam tube.
3. Position the new protection ring on the foam tube, making sure that
the studs snap into the bores on the foam tube.
Replacing the handle (Type S8)
1. Unscrew the cylinder head screws (Fig. 3/5).
2. Remove the handle (Fig. 3/6) from the foam tube.
3. Insert the cylinder head screws and the discs (Fig. 3/8) into the new
handle.
4. Place the handle in the correct position on the internal thread
screws (Fig. 3/3) and screw tight.
Replacing the hand lever
1. Unscrew the screw (Fig. 3/9).
2. Remove the hand lever from the shut-off valve.
3. Clean the shut-off valve.
4. Insert the screw and the disc (Fig. 3/8) into the new hand lever.
5. Place the hand lever in the correct position on the shut-off valve
and screw tight.
Any repair work on the AWG Foam nozzles may only be performed by
the AWG Fittings GmbH customer service or by an authorised special-
ist workshop.
36 / 40
Low expansion foam nozzles S2, S4, S8
ENGLISH
MAINTENANCE
M1106B10 I Rev. 02-03/20