Visual Inspection After Each Use; Functional Test; Prerequisites - AWG S2 Originalbetriebsanleitung

AWG I Operating manual I Fittings I
5.3

Visual inspection after each use


The foam nozzle is separated from the water supply.

The foam nozzle must not be contaminated with foam agent.
If necessary, rinse the foam nozzle again as described in the previ-
ous section.
Important
1. Inspect the foam nozzle for visible damage.
2. If the device is equipped with a hand lever (option), check that it
can be operated (unpressurised).
6

FUNCTIONAL TEST

6.1

Prerequisites

All testing of the AWG Low expansion foam nozzles S2, S4 and S8
must be carried out in accordance with the manufacturer's technical
documentation and must be documented if necessary.
The following inspections are defined for the foam nozzles:
– Mandatory BASIC Inspection after each use
– Mandatory STANDARD Inspection every 12 months
– Optional ADVANCED Inspection every 12 months
The STANDARD and ADVANCED inspections may only be carried out
by qualified personnel who have been trained for these inspections:
– Firefighters who have received training as firefighting equipment
maintenance technicians or persons with equivalent qualifications
– or, if desired, directly by the manufacturer
Inspection by the manufacturer
AWG Fitting GmbH offers an inspection as part of its service offering.
Send us the foam nozzle and you will receive the inspected device
back by the agreed date. You will find a return delivery form on our
website www.awg-fittings.com. If required, a rental device can also be
provided.
M1106B10 I Rev. 02-03/20
Low expansion foam nozzles S2, S4, S8
Do not continue to use damaged components!
If you discover any damage, this must be reported
to the person or department responsible.
ENGLISH
USE
33 / 40