Symbol Description; Screen Introduction - SATA 03015 Bedienungsanleitung

03015: Insert the red test probe into the "Input" jack when current between 400mA-20A is to be measured.
03017: Insert the red test probe into the "Input" jack when current between 600mA-20A is to be measured.
7） " "jack
Insert the black test probe into the "Input" jack in all cases of measurement except for temperature measurement.
When temperature is to be measured, insert the negative plug at the cold junction of the thermocouple into the "Input" jack.
8） " " jack
03015: Insert the red test probe into the "Input" jack in all cases of measurement except for measurement of current above 400mA.
03017: Insert the red test probe into the "Input" jack in all cases of measurement except for measurement of temperature and
current above 600mA.
When temperature is to be measured, insert the positive plug at the cold junction of the thermocouple into the "Input" jack.
9） " "button
Used to enter or exit the relative value measurement mode.
10） " "button
Press the button to hold the reading on the screen and the LCD displays "
will exit data hold mode and the "
Press this button down again for about 2 seconds to switch off the backlight.
11） Sheath
Beeper introduction:
1） When any button is pressed, the buzzer will make a short "beep" if the button is active.
2） The buzzer makes several short "beep" continuously about 1 min before the meter is powered off automatically. The buzzer makes a
long "beep" before the meter is powered off.

Symbol description :

AC （alternating current）
DC （direct current）
AC or DC
Caution! Danger! Please read the User Manual before using it.
Caution! Risk of electric shock!
Screen introduction：
03015/03017
" symbol will disappear. Press this button down for about 2 seconds to light up the backlight.
中文
EN DE
" simultaneously. Press this button again, the meter
in compliance with EU Directives
Fuse
Ground
Meter with double or strengthened
insulation protection
RU KO PT JA ES
27