LD Systems STINGER MIX G2 Serie Bedienungsanleitung Seite 9

CONNECTIONS, CONTROLS, AND INDICATORS:
18
POWER-LED
Lights up once the system is properly connected to the power mains and switched on.
19 MONITOR
Volume control on the monitor channel. The signal corresponds to the sum signal and is tapped before the
volume control of the sum channel (MAIN LEVEL), and is therefore independently adjustable.
20 MONITOR OUT
Balanced mono output with 6.3 mm jack. Connection possibility for a further active speaker. Level adjustment
via the MONITOR volume control (No. 19).
21 MAIN POWER OUT
Output (6.3 mm jack) with 70 W RMS amplifier power for a passive speaker (e.g. LDMIX6G2 The impedance
of the connected speakers should not be less than 4 ohm. The volume is set to be parallel with the master
volume on the volume control MAIN LEVEL (No. 16). The signal corresponds to the sum signal.
22
PHANTOM ON / OFF
Switchable 15 V phantom power for the microphone inputs on channels 1 to 3 (CH1 - CH3). In "ON" position,
the phantom power is on and off in the "OFF" position.
23 REC OUT
Line output on RCA connectors. The present signal corresponds to the sum signal and is tapped before the
volume control of the sum channel (MAIN LEVEL), and is therefore independently adjustable.
24
110 - 120 V / 220 - 240 V
Switch for setting the operating voltage. The mains voltage of your power supplier and the operating voltage
of the device must be the same!
25 IEC POWER SOCKET WITH INTEGRAL FUSE HOLDER
IMPORTANT INFORMATION: BEFORE using this equipment, make certain that the mains voltage of your
energy utility and the operating voltage of the device match! Always replace the fuse with a fuse of the same
type and values according to the supply voltage (see label on the rear panel)
If the fuse blows repeatedly, please contact an authorised service centre.
26 POWER ON / OFF
On / Off switch for the power supply of the device.
9