Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
1.
Before starting to wire, make sure that all the units to be connected are OFF.
2.
Unscrew the fixing base from the ring lock to separate the camera, as in figure.
3.
Fix the base to the surface with 4 screws. If it is not planned an hidden installation of connection
cables, use the slot present on the base to draw out the connection cables present on the camera
body, without pinching them, in order to avoid malfunction.
4.
Bring the cover near the fixing base and screw the ring lock to the fixing base without tightening.
5.
Adjust the camera slant as regards the desired image capture point.
6.
Screw tightly the ring lock to the camera base.
7.
Connect the video output to the selected user device.
8.
Power the camera.
6
PROTECTIVE
DOME
RING LOCK
Power wire
Wideo output wire
FIXING BASE
BODY CAMERA
Video input
DS1092-161
Werbung
Inhaltsverzeichnis
