Assembly And Operation - Bestway Flowclear AQUATRONIX Benutzerhandbuch

Assembly and Operation

WARNING For Charging
• Use only the original external adaptor and provided charging cable.
• Make sure the robot and the charger port are clean and dry before set-up.
• Make sure that the robot is turned off by sliding the switch to OFF position prior to charging.
• Fully charge the robot (about 5-6 hrs) before using it for the first time.
• Power indicator light: No light - Power off / no power
Light - Power on
Blinking light - Battery power will cease within 10 minutes.
Note:
Once the robot begins charging, the indicator light on the external adaptor will turn red. When the robot is almost fully charged, the indicator light will turn green.
1
5 6
2 4
7
8
Note:
Pry to detach the float cover and release the rope from the float to the depth of pool water plus about 0.5 m (19.7 in.)
2
Fixed locking pin
Left
Left Right
Factory setting of the pin for all
types of pool.
8.1
8.4
3
4.5-5 h
RED light – Charging
GREEN light - Charged
Right
If the robot trajectory is too curved,
pull out the pin and insert it in this
hole. Make sure the wheel axle is
positioned below the axle.
2
1
1
8.2
3
4
To increase the curve of the trajectory,
remove the pin from the hole and
insert it in the hole which is located
above the pin hole as shown.
1
2
8.3