Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Bestway Flowclear AQUATRONIX Benutzerhandbuch

Akkubetriebener, automatischer poolsauger
Vorschau ausblenden Andere Handbücher für Flowclear AQUATRONIX:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
3. Remove the battery pack to expose the PCBA. To detach the battery connection wire,
press the clip on the connector and then pull it out. NOTE: Wrap the connector immediately
with insulating tape in order to avoid short circuit caused by contact of both wire terminals.
DISPOSAL
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.

Troubleshooting

Problem
Robot does not capture debris.
Robot stopped moving in the middle
of pool(swivel head still turning).
Robot does not cover the entire
pool / move along the pool wall.
Robot trapped in the narrow place
of the in-ground pool.
Robot moves slowly.
Possible Cause
Battery is low.
Impeller is jammed.
Impeller is broken.
Debris compartment is full.
Robot stopped by obstacle.
Robot is stopped by suction force
from main pool floor drain.
Debris compartment is full.
Operation time is shorter than
expected.
Moving direction is interrupted by
water circulation generated
by filtration system.
Wheel is jammed.
Locking pin position is not correct /
bumper is required.
Robot moves along the pool wall of
round pool.
Not enough space for robot to change
directions.
Debris compartment is full.
Charge the robot again.
Power off the robot and visually check the hole under the debris.
For assistance, please visit the support section on our website,
www.bestwaycorp.com.
WARNING!
Make sure the robot is powered off before
servicing the device.
For assistance, please visit the support section on our website,
www.bestwaycorp.com.
Clean the debris compartment and filter cover.
Check to see that if there is object obstructing the cleaner.
Remove the obstacle.
Turn off the filtration system (See instructions in manual).
Clean the debris compartment
Clean the filter compartment and recharge the robot again for
5 - 6 hrs
Turn off the filtration system (See instructions in manual).
Check and clean out debris from the wheel.
Follow manual instructions to set up the locking pin position
properly and apply bumper.
Make sure the bumpers have been installed (See instructions in
manual).
Follow manual instructions to put bumper on both ends of robot.
Clean the debris compartment and filter cover.
6
Solution

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

58482

Inhaltsverzeichnis