TFA PRIO Bedienungsanleitung Seite 13

TFA_No. 30.3069_Anleitung
PRIO – Wireless Thermometer
Therefore, please note the following steps:
• The recommended distance to any interfering sources like com-
puter screens or TV sets is at least 1.5 - 2 meters.
• Within concrete walls (reinforced with steel) such as basements,
the received signal is naturally weakened. In extreme cases,
please place the unit close to a window to improve reception.
• During night-time, the atmospheric interference is usually less
severe and reception is possible in most cases. A single daily
reception is adequate to keep the accuracy deviation under
1 second.
7. Operation
• The device will automatically quit the setting mode if no button
is pressed for 20 seconds.
• Press and hold the + or – button in setting mode for fast mode.
7.1 Manual settings
• Press and hold the SET button in normal mode for three seconds
to enter the setting mode.
• DEU (default) flashes on the display.
• Press the + or – button to set the day-of-the week language: GER-
MAN (DEU), SPANISH (ESP), FRENCH (FRA) or ENGLISH (ENG).
• If you select English, the display will now appear in English.
• Press the SET button again to do the settings in the following
sequence: the button tone (BEEP ON - default), DCF reception
(DCF ON - default), the time zone (UTC 0 - default), the 12 or 24
hours system (24 Hr - default), the hours, the minutes, the year,
the month, the date, the month/day sequence D/M or M/D (D/M
- default) and the temperature unit °C or °F (TEMP °C - default).
Press the + or – button to adjust it.
• Confirm the settings with the SET button.
• If the DCF reception is activated (DCF ON), the manually set time
will be overwritten by the DCF time when the signal is received
successfully.
24
21.04.2020 15:00 Uhr Seite 13
PRIO – Wireless Thermometer
7.1.1 Key tones
• Press the + or – button to activate (BEEP ON) or deactivate
(BEEP OFF) the key tone in setting mode.
• Confirm the setting with the SET button.
7.1.2 DCF reception
• By default, the DCF reception is activated (DCF ON) and after
successful reception of the DCF signal no manual time setting is
necessary.
• Press the + or – button in setting mode if you want to deactivate
the DCF reception (DCF OFF).
• Confirm the setting with the SET button.
• The DCF reception symbol disappears.
7.1.3 Time zone setting
• In the setting mode, press the + or – button to make the time
zone correction (-12/+12).
• The time zone correction is needed for countries where the DCF
signal can be received but the time zone is different from the
DCF time (e.g. +1=one hour plus).
• Confirm the setting with the SET button.
7.1.4 24- or 12-hour system setting
• You can choose between the 12- or 24-hour system in setting
mode.
• Press + or – button.
• In the 12-HR system AM (before noon) or PM (after noon)
appears on the display instead of the seconds.
• Confirm the setting with the SET button.
7.2 Maximum/Minimum function
• Press the MAX/MIN button in normal mode. MAX appears on the
display.
25