Hazard Levels - Kärcher Iron EasyFinish Bedienungsanleitung

 The steam pressure iron
must be used and placed on a
stable surface.
 When placing the steam
pressure iron on its stand, en-
sure that the surface on which
the stand is placed is stable.
 Repair works may only be
performed by the authorized
customer service.

Hazard levels

DANGER
Pointer to immediate danger,
which leads to severe injuries or
death.
WARNING
Pointer to a possibly dangerous
situation, which can lead to se-
vere injuries or death.
CAUTION
Pointer to a possibly dangerous
situation, which can lead to mi-
nor injuries.
ATTENTION
Pointer to a possibly dangerous
situation, which can lead to
property damage.
Description of the Appliance
In the event of missing accessories or any transport
damage, please contact your dealer.
 Illustration on Page 2
1 Indicator light (orange) - heating
2 Lower steam button
3 Steam hose
4 Steam plug
Operations
Note
We recommend using the KÄRCHER ironing board with
active steam suctioning. This ironing board is optimally
matched to the device you have acquired. It facilitates
and speeds up the ironing process. In any case, the
ironing board used should have a steam-permeable,
grid-like ironing base surface.
Note
It should be noted that in the case of an ironing board
without steam suctioning, it is possible for an ironing
board cover to become wet if condensate accumulates.
ATTENTION
Material damage due to condensate/moisture
Ironing may cause condensation to drip on the floor and
damage sensitive floor coverings.
If possible, perform ironing tasks on a floor covering
which is insensitive to condensation (e.g. tiles/stone).
For sensitive floor covering, ensure that the area on
which condensation can drip is adequately protected
(e.g. water-impermeable floor mat).
Note
The iron plate must be hot to prevent steam from con-
densing on the sole plate and dripping onto the ironing
laundry.
1 Ensure that tap water or a mixture of tap water and
no more than 50 % distilled water is in the steam
boiler of the steam cleaner.
2 Insert the steam plug of the iron into the unit plug
until it clicks into place.
To disconnect:
Press the cover of the appliance connector down
and disconnect the steam plug from the appliance
connector.
3 Putting the steam cleaner into operation; see chap-
ter "Switching on the device".
4 Wait until the steam cleaner is ready for use.
5 The iron is ready for use as soon as the indicator
light (orange) has gone out.
6 The indicator light comes on during use, when the
iron is reheating. The application must not be inter-
rupted during reheating.
ATTENTION
Damage to garments
Failure to observe the ironing information in the garment
may result in damage.
Observe the ironing information in the garment.
Note
With the fixed, optimal temperature setting, all ironable
textiles can be ironed without additional temperature
setting.
Smooth delicate fabrics and imprints on the back with
steam without direct contact with the iron.
Note
The iron is fitted with an automatic switch-off which
switches off the device if it has not been moved for more
than 5 minutes. This automatic switch-off increases
safety and saves energy as the iron does not heat up
continuously. The iron will switch back on as soon as it
is moved and start heating up.
Note
The iron can be held vertically for steaming curtains,
dresses, etc.
1 As soon as the heating indicator light (orange) of
the iron goes out, ironing can be started.
2 Press the steam switch on the handle below.
Steam emits as long as the switch is pressed.
3 Before ironing and after pauses in the ironing pro-
cess, direct the blast of steam onto a cloth until the
steam flows evenly.
– 2
EN
Commissioning
Steam ironing
7