Bt Operations - auna multimedia MD-170-BT Bedienungsanleitung

Cautions
• The said product is powered by means of a 12VAC accumulator which is grounded via the negative electrode;
• Please connect as per the wiring diagram so as to avoid any device damage;
• Before connection, strip off the insulation layer long as 5mm on both ends of the wires;
• Do not power on until connection is finished;
• Insulate any exposed live part in order to prevent short-circuit with the automobile chassis. Bundle all the wires
and cables so as to prevent any terminals making contact with any metal object;
• Important: As for any automobile equipped with computer or satellite navigation system,
Attention when connecting speakers:
• Do not use any grounded speakers;
• The power of the speaker in use must exceed 40W as it is required to accept maximum output power of the
amplifier;
• The speaker has resistance ranging between 4~8ohm. Any resistance not covered by such range could affect
output power and even damage the speaker or the said product;
• The speaker wires should be approximately 30mm away from the antenna and antenna extension cable; Please
follow the diagrams below to connect correctly so as to safeguard either the speaker or the said product:
Pair with cell phone
First of all, move a cell phone close enough to the said product and then turn on the BT device in such cell phone.
Search the said product (code: 0000) for match-up.
Dial via BT
Once connected, press the Mode button to switch to "BTREADY" mode. press
dial via the numerical keypad on the remote-control (0~9) and then press
Receive calls via BT
Once connected, when there is an incoming call, press
such call. To change the call-receiving device, press and hold "2INT" on the front panel to switch among the cell
phone and the said product. When conversation is over, press
Play back music via BT
Once connected, press the Mode button to switch to the Phone mode. Launch a kind of music play- back software
installed on the cell phone to play music. Under such circumstances, press
track

BT Operations

on the front panel or
on the front panel or
to call the last number or directly
to call.
on the remote control to receive
on the remote-control.
and to select a previous or next
17