Manually Select A Channel; Special Features; Closecall® Rf Capture - Albrecht AE75H Bedienungsanleitung

channels.) When the scanner finds a transmission, it stops on it. When
the transmission ends, the scanner resumes scanning.
Notes:
If you have not stored frequencies into any channels, the scanner
does not scan.
If the scanner picks up unwanted partial or very weak
transmissions, press Func and press the scroll control knob. SqL
displays. Turn the knob clockwise to decrease the scanner's
sensitivity to these signals. To listen to a weak or distant station,
turn the knob counterclockwise.
Adjust squelch until the audio mutes.

Manually Select a Channel

You can continuously monitor a single channel without scanning. This is
useful if you hear an emergency broadcast on a channel and do not
want to miss any details – even though there might be periods of silence
- or if you want to monitor a specific channel.
To manually select a channel when in Scan mode, press Hold, enter the
channel number, and press Hold again. The scanner moves to the
frequency stored in that channel.
During scanning, if the radio stops at a channel you want to listen to,
press Hold once. (Rotate the scroll control knob to step through stored
channels.) Press Hold again or Scan to resume automatic scanning.

Special Features

CloseCall® RF Capture
Your scanner's Close Call feature lets you set the scanner to detect then
display the frequency of a nearby strong radio transmission such as
mobile and handheld two-way radios in areas with no other strong
transmission sources. However, if you are in an area with many
transmission sources (such as pager radio transmitters, multi-use radio
towers, traffic control devices, etc.), Close Call mode might not find the
transmission you are searching for, or it might find a transmission other
than the one you are searching for.
Close Call mode works well for finding frequencies at venues such as
malls and sporting events. You can set the scanner so that Close Call
66 English