Operating Determinations; Installation - EuroLite Rubberlight RL1-230 Bedienungsanleitung

Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a lighting chain for creating decorative effects. This product is only allowed to be operated with
an alternating voltage of 230 V, 50 Hz.
The lighting chain is protected against splashing water (protection-grade IP44) and can therefore be used
inside and outside.
Do not shake the device. Avoid brute force when installing or operating the device.
The ambient temperature must always be between -5° C and +45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Operate the device only after having familiarized yourself with its functions. Do not permit operation by
persons not qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

INSTALLATION

Unpack the lighting chain.
Unroll the tube, connect it with the mains and wait some minutes until it has warmed up. Disconnect from
mains and start with the installation.
Only cut the tube where marked. The tube can be cut after every 36 lamps (1 m distance).
The tube is water-proof (IP 44). Nevertheless, you have to insulate the connectors, the power-connector and
the end cap with some silicone for outdoor-use.
In order to design the desired patterns, draw the form onto the surface and attach the mounting-clips. For
free forms, you can use a stable wire in order to bring the tube into the desired form. Use tie straps in order
to connect the tube with the wire. You can fix the tie straps with the suction cups.
The minimum bending radius is 3 cm.
Bend the tube to the left side and cut off surplus wires. Bend the tube to the right side and cut off surplus
wires.
How to the connect the power-connector:
First attach the screw plug onto the tube. Attach the power-connector to the cable-ends then. Fix the screw
plug.
How to connect several tubes:
Disconnect from mains!
Make sure that you only connect 230 V-versions.
10/22 00026732.DOC, Version 2.1