Team RC 8 Gebrauchsanleitung Seite 10

Fax +32 2 359 95 50

 Then put the ingredients into the bowl. We advise you to cut ingredients like meat or
vegetables into pieces beforehand in order to get a homogeneous preparation.
 Place the lid with feeding tube onto the processor bowl as indicated in paragraph "Use"
making sure the metal shaft of the lid gets into the hole in the middle of the blade support.
 Plug in the appliance.
 For chopping, select speed 1 or 2. CAUTION: Do not try to chop very hard food (such as
ice, sugar or coffee grains...).
 When you use your appliance in an intensive way, it is necessary to make breaks of at
least 1 minute between every operation to let the motor cool down.
 CAUTION: The metal chopping blade is very sharp.
b) Grating / Slicing
Make sure that the appliance is unplugged and that the ON/OFF & speed switch is in "0"

position.
 Place the processor bowl onto the shaft and make sure that the three lugs at the bottom
of the bowl fit into the three small slots of the base and turn the bowl clockwise until it
clicks into place.
 Slide the accessory for grating/slicing onto the support with the grating blade upwards for
grating or with the slicing blade upwards for slicing.
 Place the whole on the shaft.
 Place the lid with feeding tube onto the processor bowl as indicated in paragraph "Use"
making sure the metal shaft of the lid gets into the hole in the middle of the blade support.
 Cut the potatoes, carrots, cucumbers etc. into pieces and place the ingredients into the
funnel of the bowl lid.
 Use the pusher to push food down the funnel. Never use your fingers or any other utensil.
 Plug in the appliance and turn the ON/OFF & speed switch to "1" to start. Adjust the
speed if necessary.
 Always turn the ON/OFF & speed switch to "0" and unplug the appliance before emptying
the bowl and be careful when handling the blades, as they are very sharp.
 When you use your appliance in an intensive way, it is necessary to make breaks of at
least 1 minute between every operation to let the motor cool down.
CLEANING
 Unplug the appliance.
 Turn the lid with feeding tube anticlockwise to take it off.
 Remove the accessories and the bowl. Be careful not to hurt yourself with the blades.
 Rinse the processor bowl and the accessories out and let them dry.
 Use a sponge if necessary. Be careful not to hurt yourself with the blades.
 The motor unit can only be cleaned with a slightly damp cloth.
IMPORTANT:
! Never put the motor unit under running water or into the dishwasher, but clean it with a
slightly damp cloth.
! Handle the blades carefully when cleaning. They are extremely sharp.
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
10
Assembly page 10/32
special instruction from
on the
TEAM RC 8 - 100713
Team