Compatibility measurements -
electronics
In the course of further development, extended functions may be implemented in the
electronics. This is identified by a changed firmware version (FW in Figure 1,
page 52) as well as the electronic production (as in Figure 2, page 53 and Figure 3,
page 53). Because of these reasons, the combination of the definate distribution lev-
el of measuring cell and electronics is no longer possible, so the so-called compati-
bility mark that is registered on the license plate will increase. This mark says if the
measurement and the electronics can work together (see also Table on page 39).
FW: xx.yy.zz
Figure 1
52
HW: xx.yy.zz
Product version connection board
License plate with compatibility mark
Compatibility mark
Serial number
FW edition
Document Revision
Device type
2
2
A5E00078060-04