WOLFF FRÄSMASTER 18V Originalbetriebsanleitung Seite 38

Turning on:
The unit must be in the idle
position when it is turned on.
Press the activation lock (6) so that it
1.
moves to the left/right and keep it held
down.
2. Press the main switch (5) and keep it
held down.
3. Release the activation lock (6).
4. Turn the unit in and move it into the
grooving position.
Grooving operation:
NOTE
An excessively high feed rate will reduce the
performance of the unit, impair the cutting
quality, and shorten the cutter blade service life.
WARNING
The cutter blade will continue running for a brief
period after you turn the unit off. When the
rotating cutter blade makes contact with the
material, there is a risk of recoil.
5. Move the FRÄSMASTER 18V forward along the
seam in a straight line and at a constant feed rate.
We recommend guiding the FRÄSMASTER 18V with
both hands by placing one hand on the handle (4) and
the other hand on the cutter blade housing or on the
auxiliary handle (8). Do not cover the air slots on the
cover plate (21) with your hand. If you are only able to
guide the FRÄSMASTER 18V with one hand, place one
hand on the handle (4). Keep your other hand clear of
the cutting area.
38
Idle position
6
5
Grooving position
Feed direction