WOLFF FRÄSMASTER 18V Originalbetriebsanleitung Seite 37

Battery level
You can check the battery level by pressing the button and looking at the LED lights on the battery indicator.
The indicator goes off after five seconds. If any of the LED lights are flashing, it means that the battery
needs charging. If the LED lights are not illuminated when you press the button, it means that the battery is
defective and has to be replaced.
Turn-on – Grooving – Turn-off
DANGER OF INJURY
Keep your hands away from the cutting area and the cutter blade. Hold the unit with both hands. If
you hold the grooving machine with both hands, there is no risk of injuring them on the cutter blade.
The unit is only intended to operate with the cover plate (21) securely fastened. Stay clear of the
area in front of and behind the rotating cutter blade.
_______________________________________________________________________________
WARNING
RISK OF INJURY due to flying particles.
The FRÄSMASTER 18V is only to be operated with the ejector tube (7) fitted along with a
-
dust bag (3).
- Wear eye protection.
- Never reach into the chip ejector.
- For safety reasons, the main switch (5) is not locked and you have to keep it pressed during
the grooving operation. Only turn on the FRÄSMASTER 18V once it is in the idle position.
The grooving machine is only intended to operate with the cover plate (21) securely
fastened.
Before you begin to operate the grooving machine, position the guide roller (9) and rear guide roller (20)
correctly in the direction of the groove. Do not move the unit out of position while it is stationary on the floor,
as the guide roller (9) and rear guide roller (20) will scratch the floor covering.
37