Grundig GML-2810U Bedienungsanleitung Seite 12

Transparency (0-100):
Adjust the transparency of the OSD on the display.
Reset:
Return the display to factory settings.
Information:
Current display input and resolution.
10. Frequently Asked Questions
The Power button does not respond:
- Check the power cord to ensure that it is securely plugged into the monitor base and
also into the electrical outlet.
- Ensure that there is electrical power coming from the AC outlet. Use another device to
check the power.
- Unplug the power cord of the monitor from the AC outlet, wait a few minutes, then plug
the power cord into the AC outlet again. This will reset the monitor and power supply.
No image on the screen:
- Ensure that the video signal cable is properly connected to the display card/computer.
- Check the video signal cable connector on both ends for bent or pushed-in pins.
- The display card should be properly seated in its card slot.
- Ensure that the computer's power switch is ON.
- Ensure that the monitor's power switch is ON.
- Unplug the power cord of the monitor from the AC outlet, wait a few minutes, then plug
the power cord into the AC outlet again. This will reset the monitor and power supply.
The Power LED is red (with no image on the screen):
- Check the video signal cable to ensure that it is properly attached to the video
source.
- Check the video signal cable on both ends for bent or pushed-in pins.
- Make sure the video source is not in a power-saving mode (move the mouse or press
a key on the keyboard).
No sound coming from the audio speakers:
- The audio cable should be connected to the line-out on the audio card and the line-in on
the monitor. Ensure that the audio cable is properly connected.
- Inspect the audio cable for any apparent damage. Double-check by switching to
another audio cable to see if the audio works.
12