Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Antennas - Denon TU-201SA Bedienungsanleitung

Am-fm stereo tuner
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 15
3

CONNECTING THE ANTENNAS

Installing the FM indoor antenna
Tune in FM station (see Page 8), set the antenna so that
distortion and noise is minimal, then secure the tip of the
antenna in this position using tape or a pin.
AM loop antenna
FM antenna
ANTENNA TERMINAL
FM
LOOP ANT.
COAX.
75
Connecting an FM outdoor antenna
If good reception cannot be achieved with the included
FM antenna, use an FM outdoor antenna. Connect an IEC-
type connector to the coaxial cable and connect the
antenna to the FM COAX (75 Ω/ohms) terminal.
Selecting a place for the FM outdoor antenna
• Set the antenna so that it points towards the broadcast
station's transmitting antenna. Behind buildings or
mountains, set the antenna in the position at which
reception is best, and also try changing the direction of
the antenna.
• Do not install the antenna under power lines.
Doing so is extremely dangerous, as the power line
could touch the antenna.
• Install the antenna away from roads or train tracks to
avoid noise from cars or trains.
• Do not install the antenna too high, as it may be hit by
lightning.
Downloaded from
www.Manualslib.com
Installing the AM loop antenna
Tune in an AM station (see Page 8) and set the antenna
as far from the system as possible to keep distortion and
noise is minimal. In some cases, it is best to invert the
polarities. AM broadcasts cannot be received well if the
loop antenna is not connected or if it is set close to metal
objects.
Assembling the AM loop antenna
1
2
Remove the vinyl tie
and take out the
connection line.
4
a. With the antenna
on top any stable
surface.
AM
Mount
b. With the antenna
attached to a wall.
Installation hole
Mount on wall, etc.
manuals search engine
Installing an AM outdoor antenna
Connect the signal wire from the AM outdoor antenna to
the antenna terminal. Be sure to connect the signalground
wire to the
terminal. Also be sure to connect the
included AM loop antenna.
AM
Connect to the AM
antenna terminals.
LOOP ANT.
3
Bend in the reverse
direction.
AM loop antenna
Signalground
AM outdoor antenna
ENGLISH
5

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis