Timer Function; Setting The Sleep Timer; Troubleshooting; Specifications - Denon TU-201SA Bedienungsanleitung

ENGLISH
(2) Auto power on function
(when connected to the PMA-201SA)
When the system is set to the standby mode, the power turns on automatically when one of the preset buttons
2
(PRESET < or >) or the number buttons on the remote control unit RC-906 is pressed, and the radio program is
tuned in.
(3) Auto function selection
(when connected to the PMA-201SA)
Use this function to switch the function to "TUNER" when one of the preset buttons (PRESET < or >) or the
2
number buttons on the remote control unit RC-906 is pressed, and the radio program is tuned in.

(4) Timer function

(when connected in a system with the 201SA series)
The power can be set to turn on and off at a specific time or at the same time everyday, in any modes: tuner
2
("TUNER"), CD player ("CD"), cassette deck ("TAPE"), MD recorder ("MD") and timer recording (recording to the
cassette deck ("AIRCH") or the MD recorder ("AIRCH MD") from the tuner).

(5) Setting the Sleep Timer

With this function, the power can be set to turn off after 10 to 60 minutes, in steps of 10 minutes, using the remote
2
control unit.
RC-906
(system remote
-
control unit)
TAPE
SLEEP FUNCTION MODE
1,2
CD
TUNER
MD
CD-R
TAPE
Example: To turn the power off after 50 minutes.
(This operation is only possible from the remote
control unit (RC-906).)
Press the SLEEP button.
1
Press the SLEEP button again while the
"SLEEP" indicator is flashing.
2
The previous display reappears after 5 seconds.
3
The "SLEEP" indicator remains lit, indicating
that the sleep timer is functioning.
• The time is reset to "60" (60 minutes) if the SLEEP
button is pressed again while the sleep timer is
functioning.
14
Downloaded from www.Manualslib.com
Cancelling the Sleep Timer
Press the SLEEP button repeatedly until the "SLEEP"
indicator turns off.
The sleep timer is also canceled if the power operation
switch or the power operation switch on the remote
control unit is pressed, turning the system power off.
NOTE:
If a several timer operations are set at once, the sleep
timer has priority.
manuals search engine
9

TROUBLESHOOTING

Check the following once more before assuming there is a problem with the system.
1. Are connections proper?
2. Is the system being operated as explained in the operating instructions?
If the system does not seem to be operating properly, check as shown on the table below. If none of these checks apply
to the problem, the system may be malfunctioning. Disconnect the power cord immediately and contact your store or
purchase.
Symptom Cause
• Is the power cord plugged into a
Power does not turn on.
power outlet?
• Is the antenna cable properly
connected?
Hissing noise is heard • Is there interference from an
when an FM station is electronic device equipped with a
tuned in. microprocessor, or is the signal of
the FM station weak?
• Is there interference from a TV set,
Scratchy or hissing noise
or interference from another
is heard when an AM
broadcast station?
station is tuned in.
Humming noise is heard • Is the signal carried over the power
when an AM station is cord being modulated by the power
tuned in. supply frequency?
10

SPECIFICATIONS

Reception frequency range:
Practical sensitivity:
FM stereo isolation:
FM S/N ratio:
FM harmonic distortion:
Timer functions:
Power supply:
Power consumption:
External dimensions:
Mass:
• For improvement purposes, specifications and design are subject to change without notice.
Remedy
• Plug the power cord into a power
outlet.
• Connect the antenna cable properly.
• Change the position of the
equipment or change the position or
direction of the connection cords and
antenna.
• Connect an outdoor antenna.
• Turn off the TV.
• Change the position or direction of
the AM antenna.
• Connect an outdoor antenna.
• Insert the power plug in the opposite
direction.
• Connect an outdoor antenna.
FM : 87.50 MHz ~ 108.00 MHz
AM : 522 kHz ~ 1611 kHz
: 1.2 µV/75 Ω/ohms (12.8 dBf)
FM
AM : 18 µV
40 dB (1 kHz)
Monaural: 77 dB Stereo: 71 dB
Monaural: 0.3% Stereo: 0.4%
Everyday timer (1 setting)
Once timer (1 setting)
Sleep timer (maximam 60 min.)
AC 230V, 50 Hz
9W (Approx. 1W in standby mode)
250 (W) x 90 (H) x 352 (D) mm
(including feet, controls and jacks)
2.8 kg
Refer to
page
6
5
4, 5, 6
5
—
5
5
—
5