Troubleshooting - Samsung DVD-L300W Bedienungsanleitung

ENGLISH

Troubleshooting

If your DVD player does not seem to be functioning properly, check the items below before you contact a Samsung authorized service center.
Symptom
Power does not turn on or
• Make sure the AC power cord is securely plugged into an AC outlet.
suddenly turns off.
• Turn the power off and then back on.
• Check that the battery pack is charged. If not, recharge it.
Battery pack is in place but
the power does not turn on
or suddenly turns off
Remote control won't work • Check that the battery is inserted in the "+" and "-" direction properly.
• The batteries may be dead. Replace them with new batteries.
• Check that the signal transmission is directed at the remote control sensor on the DVD player.
• Remove the obstacle between the remote control unit and remote control sensor.
No picture or sound • Check that the video and audio cables are securely connected.
• Check that the disc is a DVD (region number 1 or all), DVD-RW, VIDEO CD or AUDIO CD.
• Do not use a disc that has scratches or dirt.
• Check that the label-side of the disc is facing up.
• The pick-up lens of the DVD player may be dirty. Contact the service center for lens cleaning.
• Check that the TV channel is set to VIDEO or AV if viewing with a TV.
• Press power on from a cold start with no disc in the unit. Press the STOP and PLAY buttons
Forgot password
simultaneously on the unit for three seconds. The Select Menu Language display will appear.
Select the desired language by using UP or DOWN button. Press the MENU button on the remote
control to select the Parental Mode. The Parental Mode is now unlocked as indicated on the display.
Press the DOWN button to select Parental. Press ENTER and the Create Password display will
appear. You can now set your rating level and change your password to a new number.
The built-in micro controller can be influenced by external electrical noise. If you believe this may be the cause of the
problem, turn off the DVD player and then back on.
60
Check
Troubleshooting
Symptom
• Check that the LCD display is turned on.
No picture
No sound • Check that the display panel is open. If it is closed, audio will not be output to the speakers.
• Check the volume setting. If set to zero, turn up volume level.
• Check that the headphones are plugged into the PHONES jack.
Speakers cannot be used with the headphones.
No picture and sound • Check that the DVD player is in the DVD mode and not in the INPUT mode.
Distorted video or sound • Use a disc without scratches or dents.
While in the input mode,
• Check that the video or audio cable is securely connected.
no picture is output from
• Make sure the S-Video cable is used for output only.
the external component
to the DVD player
• Check that the DVD player is in the INPUT mode and not in the DVD mode.
Check
ENGLISH
61