KLIM Ai-1 Benutzerhandbuch Seite 10

5. Check the integrity of the In&motion airbag system
Take your inflation adapter, which is provided with your spare
inflator. To purchase a new inflator, you can go on www.
inemotion.com or in shops.
Screw the provided inflation adapter in the place of the inflator.
Thanks to this adapter and using a pump or a compressor,
inflate the vest to 0,3 bar (5 psi) and check that it does not
deflate in less than 5 seconds. (Any pneumatic inflation system,
such as those available in filling stations may be suitable for this
operation.).
While the vest is inflated, check the integrity of the fabric parts
and seams. Check that the seams are not fraying.
If the vest does not inflate or deflates quickly, do not use the
vest and contact your local reseller.
Otherwise, remove the adapter by unscrewing it, then
completely remove the air contained in the airbag system.
6. Install a new inflator
Warning! Do not touch the full inflator connector with your
fingers (blue piece on the bottom of the inflator). Do not connect
before having screwed on the inflator.
Warning! Before carrying out the following steps, check that the
airbag system is completely void of air.
Screw on the new inflator hand tight.
10 ENGLISH