auna multimedia MVD-310 Bedienungsanleitung Seite 37

Open /
1
down
2 Vol/SEL
3 On/Off / MODE
/
4 / 10
/
5 TA / AF
6 BND
7 MU / PTY
up/
Press to slide monitor in/out and adjust the angle.
In normal mode, the VOL knob is used to change the volume.
Press SEL (in radio mode: press and hold) to switch between BASS, TREBLE,
BALANCE, SWF VOL, and SWF FRQ.
After switching to the desired parameter, change the value rotating the VOL
knob or press VOL+/-.
In radio mode, press SEL to select MANUAL or AUTO mode, to either manu-
ally or automatically scan for your desired radio station / frequency.
Press to turn the unit on.
Hold to shut down.
During playback, press to change modes (RADIO, USB, CARD, AUX IN, BT
MUSIC).
Radio: Hold for automatic station scan (up). Press short to manually step up
frequency (steps of 0.05Hz).
Media playback: Press for next Track; hold (repeatedly) for fast forward (x3,
x4, x8 x20, x1)
BT-Mode: For the function of
TA (Traffic Announcement): In radio mode, swing the MU/PTY knob to TA/
AF. When TA is activated, an icon will be displayed while active.
AF (Alternative Frequencies): Swing and hold the MU/PTY to TA/AF (hold
for 2 seconds) to activate AF. Repeat to de-activate.
In Radio mode, press and hold the SEL knob to access the selection menu:
REG ON/REG OFF - PI Mute/PI SOUND - AF ON/AF OFF.
Radio: Cycle through the available bands (FM1, FM2, FM3, AM(MW1),
AM2(MW2))
MUTE: Press to mute/unmute all signal output.
PTY: Press and hold to select the PTY of the program type (News, Pop, etc.).
/ please see BT section below.
37