Troubleshooting - Traedgard Design KOMPAKT MIDI Handbuch

TROUBLESHOOTING

PROBLEM:
Pilot flame does not
light
Pilot flame does not
stay on
Burner does not
burn
Burner flame is
small Note:
CAUSE:
Cylinder valve is closed
Blockage in opening or
Ignition hose
Air in the gas hose
Low gas pressure
Ignition does not work
Accumulations of dirt around
the
Pilot light
The connection between the
gas valve and pilot light is
loose
Defective thermocouple
Gas pressure is too low
Blockage in the opening
Control knob is not in the
„ON" postion
Gas pressure is too low
Outside temperature is over
5°C (40°F) and tank is less
than 25% full
35
TROUBLESHOOTING:
Open valve
Clean or replace opening or
ignition hose
Open the gas supply and vent it
(press the rotary knob in) for a
maximum of 1-2 minutes or until
you smell gas.
Gas cylinder is empty or almost
empty.
Light the pilot flame with a match,
insert a new ignition.
Remove dirt from the pilot light
Tighten the connection and
do a leak test
Replace thermocouple
Replace the gas cylinder
Remove blockage
Turn the control knob tot he „ON"
postion
Replace the gas cylinder
Replace the gas cylinder
EN