Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Grinding Angle
wrong
Edge curving curwing
backwards
Adjustment Screw
1. With the adjustment screw (1) you can adjust the position of the stone in
the machine. This way the pressure with which the stone is forced against
the stone is set.
2. Turn the screw to the left to lower the stone. Turn the screw to the right to
raise the stone. Do not raise the stone too much; otherwise it may hit the
housing.
Replacing the Stone
1. Loosen the two Phillips head screws which hold the drill guide in the
sharpening head. Remove the guide and lift the stone and the shaft out.
Loosen the screw mounting on the grinding stone.
Operation
Cutting Angle has to be 8 – 12°
Point Angle 125 – 135°
wrong
forwards
correct
Edge
straight
10
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
