Inhaltsverzeichnis
Werbung
Video Intercom D Series Door Station User Manual
Notify Surveillance Center
Send an exception or alarm signal to the remote management software
when an event occurs.
7. Click Save to enable the settings.
Set Video Tampering Alarm
When the configured area is covered and cannot be monitored normally, the alarm
is triggered and the device takes certain alarm response actions.
Steps
1. Click Event → Basic Event → Video Tampering to enter the settings page.
2. Check Enable Video Tampering.
3. Draw area.
1) Click Area Settings.
2) Click
, and drag the mouse in the live view page to draw an area.
3) Optional: Click
4. Drag the block to set the Sensitivity. The higher the value is, the easier to detect
the area covering.
5. Optional: Click Linkage Method, and check the normal linkage or notify
surveillance center according to your actual needs.
Normal Linkage
Set the normal alarm linkage.
Notify Surveillance Center
The alarm information is uploaded to the surveillance center when an alarm
event is detected.
6. Optional: Click
7. Click Save to save the settings.
Event Linkage
Steps
1. Click Event → Basic Event → Event Linkage to enter the settings page.
to clear the drawing area.
or
to perform the record or capture operation.
46
Werbung
Inhaltsverzeichnis
