National Instruments NI USB-TC01 Bedienungsanleitung Seite 4

Installing the NI USB-TC01
Note Your NI USB-TC01 needs to be connected to the computer for the NI USB-TC01
Launch Screen to open. If the NI USB-TC01 is connected to the computer and the
NI USB-TC01 Launch Screen does not appear, refer to the NI USB-TC01 support page.
The NI USB-TC01 support page is accessible from the NI USB-TC01 Launch Screen by
selecting the Device Support link or from
If Autoplay does not start, locate the NI USB-TC01 under My Computer and
Note
double-click
NI USB-TC01 User Guide and Specifications
The NI USB-TC01 software support for Windows 7/Vista/XP is provided
by the device. No separate driver installation is required for operation.
1
1 USB Cable
2 NI USB-TC01 Device
Complete the following steps to set up the NI USB-TC01:
1. Plug the thermocouple into the thermocouple input on the
NI USB-TC01 device. Refer to the
more information.
2. Connect the NI USB-TC01 USB cable into an available USB port on
the computer. On first connection to the computer, it may take a few
seconds for the operating system to detect and configure the
NI USB-TC01 device.
Once the device has been successfully detected, the NI USB-TC01 Launch
Screen will open (as shown in Figure 3), or a Windows Autoplay dialog
will appear allowing you to select TC01Launcher.exe to run the software.
TC01Launcher.exe
3 Thermocouple Input
4 Minithermocouple Connector
Figure 2. NI USB-TC01 Components
Thermocouple Input
ni.com/info
to manually run the software.
4
2
3
4
section for
by entering infocode
USBTC01
.
ni.com