Names And Functions Of Parts - Panasonic MKG1500-DE Serie Installationsanleitung

2-1. Names and Functions of Parts

CT connector
Display of CT connector
(
from left, main line,
Photovoltaic, storage battery
POWER LED
(Green when ON)
SEND LED
(Red during send)
RECEIVE LED
(Red during receive)
Strip gauge
Display of voltage phase
For 3-Phase 4-Wire : Use V1,V2,V3,VN
For Single-Phase 2-Wire : Use V1,VN
Power terminals
REGISTER LED Patterns
Status
Home IoT Gateway Not
Registered
Register Mode
Communications Mode
Registered with Home
IoT Gateway but not
connected
* Holding the SET button in communications mode will re-start Register mode and delete the current registration.
If the button is accidentally held, go through the wireless registration process again (see p17).
)
LED Pattern(green)
Slow flash (1 sec interval)
Quick flash (0.5 sec)
LED turns on when shifting to
Communications mode
After 5 mins LED turns off
Quick flash (0.5 sec)
ERROR LED
(Red if error, Off when normal)
SET button
(
REGISTER LED
(
Hook
Hold (3secs) SET button to enter Register mode
If no status change for 5 mins, LED turns off
Register Mode runs only for 5 seconds
Communications mode begins once successfully
connected to Home IoT Gateway
Do not press the SET button when in
communications mode*
Communications mode begins once successfully
connected to Home IoT Gateway If no status
change for 5 mins, LED off
8
Hold (3 secs) to enter Register
mode
See below for REGISTER LED
patterns
Flashes green depending on
status
See below for REGISTER LED
patterns
Notes
)
)