Connecting To Home Iot Gateway; Removing And Exchanging - Panasonic MKG1500-DE Serie Installationsanleitung

4-3. Connecting to Home IoT Gateway

Connection of the Home IoT Gateway (MKG100913) to the Power Measuring Unit should be made according
to the app and Home IoT Gateway user manual (https://industry.panasonic.eu/energy-building/home-iot).
1
Check the Home IoT Gateway is available.
2
Carry out the wireless registration process on the Home IoT Gateway side.
For details, see the Home IoT Gateway user manual.
3
Start the measuring unit and check REGISTER LED flashes. Then, hold the SET button (3 seconds or more)
to enter Register mode. During Register mode, REGISTER LED flashes with an interval of 0.5 seconds.
*Do not press SET button during Register mode
4
Once communication with the Home IoT Gateway is established, Register mode will end and the
RECIEVE / SEND LED light will illuminate, followed by the REGISTER LED (which will turn off after 5 min).
5
Use the app to confirm that the wireless signal functions with the cover and door closed.
6
Use the app to confirm that the device can measure the power accurately.

4-4. Removing and Exchanging

Caution: When removing and exchanging a Power Measuring Unit, be certain to switch the power connection
breaker and main breaker OFF.
Detaching the Power Supply
Insert a flat-head screwdriver into the screwdriver aperture and pull on the power wire.
Use a 2.0 to 3.5 mm flat-head screwdriver.
V2
V1
Screwdriver
aperture
Exchanging the Power Measuring Unit
When replacing the Power Measuring Unit, follow the replacement of Power Measuring Unit in the app.
1P2W
3P4W
VN
V3
1P2W
3P4W
VN
V3
V2
V1
17
1P2W
3P4W
VN
V3
V2
V1