General Warnings; Safety Warnings - Atlas Filtri FDM-1ME Handbuch Für Installation, Gebrauch Und Wartung

ATTENTION: the FDM-1ME filter contains strong magnets.
Always pay careful attention during installation and maintenance interventions.
Do not position the magnetic nucleus on ferrous surfaces.
ATTENTION: use suitable protective equipment during all installation and maintenance operations.
ATTENTION: to avoid damage due to frost, avoid installation in areas where the temperatures may
fall below 0°C.

GENERAL WARNINGS

Ensure that the equipment has not been damaged during transportation.
ATTENTION: the manufacturer declines any liability in case of modification of water connection,
errors caused by not following the instructions contained in the installation manuals of the
equipment and the applicable laws and regulations.
It is prohibited to use the equipment for purposes different from those foreseen.

SAFETY WARNINGS

Carefully read the instructions manual and keep it with care, possibly in proximity of the equipment
in order to consult it when needed.
- Do not leave the material used for packaging within reach of children. Dispose of materials
according to laws and regulations in force.
- If the equipment is damaged or has visible defects or operational anomalies, it is recommended
not to use it and to not try disassemble it or tamper with it. Contact the reseller directly for
repairs.
Before installation, verify that the hydraulic system is completed according to best practice.
The package contains all accessories for a quick and easy installation.
Special equipment is not required, however installation must be carried out by qualified personnel.
- For operating pressure exceeding 3 bar, it is necessary to install a pressure reducer upstream.
- Install a suitable anti-water hammer system (expansion tank, shock absorbers, etc.) downstream
from the equipment.
- Only use original spare parts and accessories.
ATTENTION: in case of non-appropriate use, not conforming to instructions of use or equipment
tampering, the manufacturer is not responsible for any damage to persons, animals or property.
The manufacturer is exempted from any liablity in the specific cases mentioned below:
- Improper use of the equipment.
- Use contrary to specific national regulations (power supply, installation and maintenance).
- Installation carried out by non qualified personnel.
- Supply water problems (pressure drops, mains overpressure).
- Operational ambient temperature not suitable.
- Unforeseen maintenance deficiencies.
- Unauthorised modifications or interventions.
- Use of non original spare parts.
- Total or partial non-compliance with instructions.
MAINTENANCE MANUAL
FILTERING CARTRIDGE CLEANING:
It is possible to carry-out periodic cleaning operations of the cartridge by unscrewing the lower
discharge cap or the closing cap with magnet.
Before cleaning the FDM-1ME filter, it is recommended for the boiler to be turned off and for the
FDM-1ME filter to be allowed to cool down to room temperature before starting any maintenance
intervention, in order to avoid damages and burns.
Close the supply valve.
Carefully unscrew the lower discharge cap and allow the water to flow out (image 1).
If installing the filter vertically, unscrew the magnet-holder cap directly (image 2).
NOTE: collect the water flowing out of the filter in a suitably sized container.
- Once the water flow has been cut off, unscrew the closing cap with magnet.
OUT - boiler
IN - system
Application of FDM-1ME
with main cartridge holder /
magnet body aimed downwards.
- 8 -