Remote Control - Koenic Kac3231 Gebrauchsanleitung

English
Operation
Fig. Switching on/off
5
The product can only be switched into
Standby. Unplug in order to disconnect
from the mains.
Press the on/off button
OFF button to switch the product on or
standby.
Note:
• After a power break or when the product
is switched into standby and on again in
a short time, the refrigerating compressor
will resume work after 3 minutes (delayed
start). This is to prevent the cooling circuit
from damages.
• If the product is tilted over, switch it
standby and unplug immediately. Wait
at least 2 hours before operating the
product again to avoid damages on the
refrigerating circuit.
• Always switch the product into standby
before unplugging.
26
IM_KAC3231_161201_V06_HR.indb 26

Remote control

Fig.
6
or the ON/
Note:
• Press any button on the remote control
and the product adopts the current
setting from the remote control.
• The signals of the remote control will
be transmitted with a short delay after
a button is pressed. This process is
indicated by the appearing
the remote control display.
• Every press of a button on the remote
control will illuminate the display on the
remote control for a few seconds for
better visibility in the dark.
Control
panel
+
MODE
FAN
SLEEP
SWING
—
TIMER
—
Remove the battery compartment cover.
Insert 2 batteries (type LR03/ AAA) while
paying attention to the correct polarity.
Close the battery compartment. Using
the control panel and the remote control
alternately might lead to a misalignment
of the product and the information
displayed on the remote control.
Remote
Function
control
Switch on or standby.
ON/OFF
Increase value, e.g.
TEMP
temperature or timer
Decrease value of
TEMP
temperature or timer
Mode selection button
MODE
Fan speed selection
FAN
button
Sleep mode on/off
SLEEP
Fan outlet oscillation
SWING
on/off
Display and indicator
LED
lights on/off
Adjust switch standby
TIME
OFF
+
time
on
–
off
TIME
Adjust switch on time
ON
Choose preset mode
SHORT
and temperature
CUT
symbol on
1/12/16 4:21 PM