Information On Cables And Connections; Audio Connections; Cables And Plug Configurations - Fohhn D Serie Bedienungsanleitung

7. Information on cables and connections

7.1 Audio connections

Before connecting the DSP-amplifier to the mains power supply,
make sure that the mains voltage corresponds to that specified on
the rear panel (tolerance of +/- 10% is permitted). Always plug in
the mains cable before switching on the DSP-amplifier and always
switch off the DSP-amplifier before disconnecting it from the mains
power supply.
All other cables should be connected when the DSP-amplifier is
switched off and the mixing desk should be switched on before the
DSP-amplifier is switched on. This prevents annoying and often
dangerous switch-on noises.

7.2 Cables and plug configurations

When connecting a mixing desk to the DSP-amplifier, always make
sure the screened cable is intact. Unscreened cables may cause
problems relating to signal or hum interference. When connecting
the speakers, please use high-quality SPEAKON cables. Check the
condition of your cables on a regular basis.
XLR
2 1
3
T S
T R S
2
3
1
2
3
1
18 | D-Series Amps
Downloaded from www.Manualslib.com
Speakon
Jack
+1 +2
-1 -2
T R S
T
S
T
S
R
XLR Male
XLR Female
manuals search engine
XLR-RJ45
adapter
cable
USB cable