Safety Notes; Important Notes; Technical Data; Connections - LGB 51070 Bedienungsanleitung

Safety Notes

Make sure you read the following safety notes before using
this controller for the first time:
• This locomotive controller is designed for use only in dry
areas.
• This locomotive controller is not a toy. It is used to ope-
rate a model railroad layout.

Important Notes

• These instructions are an integral part of the product
and must therefore be kept with the product even if you
transfer the product to someone else.
• Incorrect hookup of this locomotive controller will dama-
ge it.
• Disposing: www.maerklin.com/en/imprint.html
Caution! Use wire with a cross section of at least 0.5 square
millimeters or 20 gauge wire to hook this locomotive control-
ler to a layout (example: LGB 50160).

Technical Data

Input voltage:
14 – 20 volts AC or
max. 16 – 24 volts DC
Output voltage: 0 – 22 volts DC
Output current: max. 5 amps DC
6
Downloaded from www.Manualslib.com manuals search engine
Connections (Fig.1, 2 & 3)
• Connect terminals 1 and 2 on the back of the locomotive
controller to the track (Fig. 2 & 3).
• Connect terminals 3 and 4 to an LGB transformer.
• You can operate the 51070 electronic locomotive
controller with any LGB transformer / switched mode
power pack. The 51095 transformer / switched mode
power pack is designed to be used with this controller.
The available track current depends on the transformer /
switched mode power pack, up to a maximum of 5 amps.
You can use a transformer / switched mode power pack
with more than 5 amps, but the maximum track current
with this controller is limited to 5 amps. The wire used to
connect the controller to the track can be a maximum of 2
meters / 78 inches long.
Radio Remote Control
The 55055 radio control receiver can be connected to the
51070 locomotive controller (Fig. 2 & 3). A locomotive's
speed and direction can be controlled without wires with
the 55016 walk-around controller (with the 55050 radio
control sender). (You can also use the 55015 universal walk-
around controller).
The radio hand controller is only active as long as the
control knob on the 51070 locomotive controller is set at 0
(center position).