Initial Operation; Using The Machine - Clatronic hm 2935 Bedienungsanleitung

GB
Ensure that the machine is not connected to the mains.
Assembly of the Whisk/Kneading Hook/Beater
Press the two whisks or kneading hooks on the bottom by turning slightly until
they lock in place.
Note: The kneading hook/whisk must be inserted into the correct opening of the
mixer!
1. Please ensure that the speed switch (2) is turned to „0/OFF".
2. Connect the mixer to a properly installed power socket, 230 V, 50 Hz.
Always choose a utensil and a speed according to the following table
Product/Type of Preparation
Heavy dough (e.g. yeast dough)
Cake mixture
Sponge mixture or wafer mixture
Cream or beaten egg-white
Liquids, shakes
Note:
For optimum results use high-walled vessels that are not too large. Tilt the machi-
ne slightly up and down.
Turbo Switch (1)
This is for switching to maximum speed for a short time. Press at short intervals
for pulsed mode operation.
WARNING: Do not use this function for more than 2 minutes!
Releasing the kneading hook / whisk
• Ensure that the machine is not connected to the mains.
• In order to release the hook, press the release button (3).
1. Before cleaning the equipment, always remove the mains plug from the
socket.
2. Only a damp cloth should be used for cleaning the outside of the machine.
3. Do not use any caustic or abrasive detergents.
4. Removable parts that have been in contact with the dough or mixture (knea-
ding utensil and whisk) can be cleaned in soapy water.
26
6....-05-HM 2935 26

Initial Operation

Using the Machine

Max. Quantity Utensil
300 g Kneading hook
500 g Kneading hook
500 g Beater
0,5 l Beater
up to 1.5 l Beater
Cleaning
Level Max. Operating Time
1 to 2 3 min
1 to 3 5 min
1 to 4 5 min
1 to 5 5 min
5 or P 2 min
18.10.2004, 18:09:18 Uhr