Troubleshooting; Maintenance; Environmental Protection - eta STEPHANY Bedienungsanleitung

GB
V. TROUBLE SHOOTING
PROBLEM
The appliance
does not work
Water is
dripping from the
plate
The plate surface
is scratched
VI. MAINTENANCE
Turn off the appliance before any maintenance, unplug the fork of the power cord
from the power supply socket and let it cool down! Do not use rough and aggressive
detergents! Carry out surface maintenance only (wipe off dust etc.) For removing old dust
or other impurities, use a soft damp cloth.
Storage
Before storage, make sure that the pot and any of its parts have cooled down. Store the
appliance in a safe and dry place, out of the reach of children and incapacitated people.
VII. ENVIRONMENT
Printed signs of materials used for manufacture, packing, components and accessories,
as well as their recycling, are on all the pieces if their dimensions enable it.
CAUSE
Power supply not connected
You have not pressed the steam
button A1 fully
AUTO SHUT OFF function
activated
The water tank is not in place.
The water level in the water tank is
too low.
You are holding the steamer upside
down, which makes it impossible
for the steamer to get water from
the water tank. You are holding the
steamer in horizontal position to
steam a garment on a flat surface
Blinking (flashing) control panel
and long beep. Malfunctioning
temperature sensor
The water tank is not in place.
The steamer has not heated up
sufficiently.
After finishing steaming, the
appliance was put into the
horizontal position and the water
tank is full
The plate was in contact with sharp
and hard objects while steaming
Check the power cord, plug
and electric socket
Press the steam button A1 fully
Appliance ON
Insert the water tank properly.
Unplug the steamer and refill
the water tank.
Hold the steamer in upright
position.
Do not use the steamer in
horizontal position or on
garments in horizontal position.
Contact an authorized service
centre
Insert the water tank properly.
Let the steamer heat up for
approx. 1 min. before using it.
Empty the container and put
the appliance into the rest
position
During steaming, avoid contact
with metal objects containing
sharp edges
26 / 52
SOLUTION