Garment Steamer Use (Fig. 2) - eta STEPHANY Bedienungsanleitung

GB
Check if the steam discharge button A1 with is in the (off) position
–
before each connecting of the appliance to the el. outlet!
– When using the appliance, you will hear an inherent noise sound and vibration. This is
normal and the appliance will not be replaced for this purpose under warranty.
– Do not use your bare hand as a supporting surface when you steam.
IV. GARMENT STEAMER USE (Fig. 2)
Connect the power supply plug A5 to the mains. To the control lights will light and a signal
(1 beep) will sound and then the garment steamer is switched automatically to the stand-by
regime is indicated by the indicator coming on
control panel A2, the appliance will switch on and water heating will be activated which is
indicated indicator
indicated by the indicator coming on. To activate steam, press and hold the A1 button.
The pump will switch on and hot steam will start coming out of the nozzles on the soleplate
A3. When steaming, always hold the A1 button pressed continuously. For easier use, the
A1 button may be locked by shifting the locking button downwards. To deactivate (unlock)
the locking button, shift it the other way round. To activate intensive steam it is necessary
to press the A6 button is indicated by the
does not produce any steam when you press the A1 button and it starts emitting a different
sound, release the button, switch off the appliance and fill up the tank with water. To switch
off the appliance, press the A6 button
appliance will switch off automatically after 8 minutes of inactivity (function AUTO SHUT
OFF) to the stand-by regime. To restart the appliance, press the button A6.
The garment steamer is easy to use. It is ideal for achieving a natural look and for quick
touch-ups = crease / fold removal from your garments. Furthermore, it can rid the garments
of undesired odour and dirt and freshen up soft furnishings (e.g. curtains, net curtains,
blankets, upholstery, bed linen).
1) Check that there is enough space behind the fabric for air circulation (otherwise, it
would cause moisture) and that no objects sensitive to heat and moisture are present
in the immediate vicinity which might get damaged by the steam.
2) Check that the garment pockets are empty and sleeves, cuffs and hems point downwards.
3) If the garment features any metal accessories (e.g. zips, buttons, etc.), be careful and
do not use the steamer directly over the metal as it would change the colour of the metal
or cause corrosion.
– Depending on the type, thickness and creasing of the fabric, select either the gentle
steaming or intensive steaming mode. For thick or very creased fabrics, we recommend
a longer time of steaming to allow penetration of a larger quantity of steam. However, be
careful so as not to apply steam unnecessarily to the same place for a long time to avoid
damaging the garment.
– When using the steamer without the brush, keep a distance of at least 5 cm between the
soleplate and the garment.
– For an optimum result, hang the garment on a hanger.
– When using the steamer, never point it at yourselves and keep it in an upright position.
Bring the soleplate A3 close to the garment, while pulling the sides of the garment with
the other hand.
Attention
flashing. Steam will be ready for use within about a minute which is
on the control panel A2. For safety reasons, the
When you press the A6 button
indicator coming on. If the garment steamer
24 / 52
on the