Cleaning And Care - WMF Stelio Gebrauchsanweisung

Crushing ice cubes
Fill with a maximum of 10 ice cubes and close the glass jar with the lid and
closing cap. Place the selector switch for a few seconds on the pulse stage P and
then back on the off position 0. As soon as the ice cubes fall back to the bottom
of the glass jar, you can switch to the pulse stage P again for a few seconds.
Repeat the process for as many times as needed for the ice to reach the desired
consistency.
General Information
1.25 l is recommended as the maximum fill level. Filling past this amount may
lead to overflowing depending on the consistency of the ingredients.
Switch the device off as soon as the amount is processed. Never operate the
device empty.
Allow the device to cool down following the maximum operating time so that the
motor is not overloaded.
For large volumes, especially thin fluid content, it is hard to pour in a directed
manner. In this case, it is better to prepare the batch in parts.
Always place the selector switch on the off position 0 before removing the glass
jar.
Attention! Risk of injury! Always wait for the blades to come to a standstill
before removing the lid. Do not reach into the device before the power plug
has been unplugged.
Completely empty the glass jar following use. Do not leave any liquid in the jar.

Cleaning and Care

Remove the power plug after use.
Never submerge the propulsion unit in water, but rather only wipe the outside of
it with a damp cloth. Do not use any abrasive cleaning agents.
Be sure to avoid injury on the sharp blades when cleaning the glass jar.
Immediately after mixing, fill the jar with warm rinsing water and allow the
motor to run for a few seconds. Then remove the glass jar and clean with a
washing-up brush.
For thorough cleaning, you can dismantle the glass jar as described in the section
entitled „Glass Jar".
For quick and easy cleaning, you can place all loose parts in the dishwasher.
11