Cleaning The Pre-Filter; Descaling The Nanocloud Rotary Humidification Wick - Philips HU5930 Benutzerhandbuch

5
Wipe the outside of the water tank
and water tray dry.
6
Place the wick wheel on the wick
support (fig. k).
Note
•
When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
7
Place the water tray back into the
appliance (fig. l).
8
Place the water tank back into the
appliance (fig. p).

Cleaning the pre-filter

Filter alert light
status
Cleaning light
goes on (fig. )
Note
•
Only the pre-filter and NanoCloud
rotary humidification wick are
washable. The NanoProtect filter is
not washable.
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig. c).
2
To remove the pre-filter, press the
two clips down and pull the filter
towards you (fig. €).
3
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig. ).
4
Air dry the pre-filter.
Follow this
Clean the pre-
filter
Note
•
Make sure that the pre-filter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-filter.
5
After the pre-filter is completely dry,
place it back into the back panel
(fig. ‚).
6
Touch and hold the reset button
for 3 seconds to reset the pre-filter
cleaning time (fig. ƒ).
Descaling the
NanoCloud rotary
humidification wick
Filter alert light
status
Cleaning light
goes on (fig. )
1
Pull out the water tank (fig. h).
2
Pull out the water tray (fig. }).
3
Take the wick wheel off the wick
support (fig. ~).
4
Soak the NanoCloud rotary
humidication wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours.
Follow this
Descale the
NanoCloud rotary
humidification
wick
EN 11