Cleaning The Pre-Filter - Philips AC1215 Benutzerhandbuch

Cleaning the pre-filter

Clean the pre-filter when F0 is displayed
on the screen (Fig.v).
1
Switch off the air purifier and
unplug from the wall outlet.
2
Pull the bottom part of the front
panel and then gently lift to remove
it from the air purifier (Fig.c).
3
Press the clip down (1) and pull the
pre-filter towards you (2) (Fig.d).
4
If the pre-filter is very dirty, use a
soft brush to brush away the dust.
Then wash the pre-filter under
running tap water (Fig.w).
5
Allow the pre-filter to air dry
thoroughly before placing back in
the air purifier.
Note
• To optimize the lifetime of the pre-
filter, make sure it dries completely
after cleaning.
• Wash your hands after handling the
filter.
6
Put the pre-filter back into the air
purifier (Fig.h).
Note
• Make sure the side with the clip is
pointing towards you, and that all
hooks of the pre-filter are properly
attached to the air purifier.
7
To reattach the front panel, press
the top part of the panel onto the
top of the air purifier (1). Then,
gently push the panel against the
body of the air purifier (2) (Fig.i).
EN
10
8
Put the plug of the air purifier in the
wall outlet.
9
Touch and hold the
3 seconds to reset the pre-filter
cleaning time (Fig.x).
10
Wash your hands thoroughly after
installing filters.
for