Guidance And Manufacturer's Declaration; Emc Compliance - Welch Allyn 719 Serie Gebrauchsanweisung

8 A - English
Item
Operating
Typical charge time
Typical discharge time
Conforms with
Charger accessory material number
Charger input
Charger output

Guidance and manufacturer's declaration

EMC compliance

Special precautions concerning electromagnetic compatibility (EMC) must be taken for all medical
electrical equipment. This device complies with IEC 60601-1-2:2014/EN 60601-1-2:2015.
• All medical electrical equipment must be installed and put into service in accordance with the
EMC information provided in this Instructions for use.
• Portable and mobile RF communications equipment can affect the behavior of medical
electrical equipment.
The device complies with all applicable and required standards for electromagnetic interference.
• It does not normally affect nearby equipment and devices.
• It is not normally affected by nearby equipment and devices.
• It is not safe to operate the device in the presence of high-frequency surgical equipment.
• However, it is good practice to avoid using the device in extremely close proximity to other
equipment.
Welch Allyn 719 Series Lithium Ion Handle and USB Charging Accessory
NOTE The handle and charging accessory has no essential performance
requirements.
WARNING The use of the handle and charging accessory adjacent to or stacked
with other equipment or medical electrical systems should be avoided because it
could result in improper operation. If such use is necessary, the handle and
charging accessory and other equipment should be observed to verify that they
are operating normally.
WARNING Use only Accessories recommended by Welch Allyn for use with the
handle and charging accessory. Accessories not recommended by Welch Allyn
may affect the EMC emissions or immunity.
Specification
Temperature 10°C to 40° C (50°F to 104° F)
Relative humidity, non-condensing 10% – 95% R.H.
Atmospheric pressure 500 hPa – 1060 hP Altitude
16 hours (fully discharged)
110 minutes (for new battery)
Complies with IEC/UL/CSA/EN 60601-1 and 60601-1-2
71955
5VDC, 0.5A
5VDC, 120mA