How To Connect - Denon DP-30L Serie Bedienungsanleitung

4. Attaching and detaching head shell on/from
tonearm
As shown in Fig. 6, align the guide pin with the slot at
(1)
the tonearm end and insert.
Turn the lock nut in the arrow direction in Fig. 6 until it
(2)
stops and fix the head shell to the tonearm.
For removing the head shell, turn the lock nut in the
(3)
opposite direction of the arrow and gently pull it off.
5. Mounting dust cover
Hold the dust cover near the hinges by both hands as
shown in Fig. 7 and push the "metal parts" of the hing-
es deep enough unto the "hinge catchers" of the cabi-
net.
For removing the dust cover, open it fully and pull it off
in the same mariner.

HOW TO CONNECT

After assembly, make the following connections. Make
correct and firm connections. Be sure that the power
of amplifier is "off".
Connect the L and R pin plugs of output cord to the L
(1)
and R "phono" inputs of the amplifier to be used. (Fig.
8)
Also connect the Y-shaped lug of ground wire (combined with
the output cord) to the "GND" terminal of the amplifier.
Note: Some cartridges may require a step-up transformer or a
head amplifier depending on their type.
Plug in the power supply cord to AC receptacle. (Or else,
(2)
if AC outlet is provided on your amplifier connect the
power supply cord thereto, referning to Fig. 8. Make
sure at this time that the power capacity of the outlet is
sufficient.)
Fig. 4 Cartridge alignement
Fig. 5 Stylus point
Fig. 6 Attaching head shell
Fig. 7 Mounting dust cover
13
Fig. 8 Connection