SEVERIN SM 3738 Gebrauchsanweisung Seite 12

to play with the appliance.
∙ Caution: Keep any packaging materials
well away from children – these materials
are a potential source of danger, e.g. of
suffocation.
∙ Every time the appliance is used, the
main body including the power cord as
well as any attachment fi tted should
be checked thoroughly for any defects.
Should the appliance, for instance, have
been dropped onto a hard surface, or if
excessive force has been used to pull the
power cord, it must no longer be used:
even invisible damage may have adverse
effects on the operational safety of the
appliance.
∙ The appliance should only be placed on a
level surface. Do not allow the housing or
its power cord to come into contact with
open fl ames or any hot surfaces such as
hot-plates.
∙ Do not let the power cord hang free.
∙ Do not touch any moving parts during
operation - this can be extremely
dangerous.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Before using for the fi rst time
Before the appliance is used for the fi rst
time, the blender jug, lid and stopper,
grinding top and blade assembly should
be thoroughly cleaned, as described in the
section Cleaning and care.
12
Switch settings
The following settings can be selected:
P The appliance remains switched at high
speed on as long as the rotary switch is
held in this position
0 The appliance is switched off
I Low power
II Maximum power
Short-term operation
The appliance is designed to process
average domestic quantities of food; it
can be operated without interruption for a
maximum of 3 minutes with the blender jug,
or up to 30 seconds with the grinding top,
after which it should be allowed to cool down
to room temperature.
Safety switch
A special safety switch in the motor housing
ensures that the appliance can only be
operated if the blender jug or grinding top is
properly locked in position.
Before removing either of these, make sure
that the rotary control is in position 0. This
also applies when fi tting the blender jug
or grinding top to the motor housing. If the
control is not in its off-position (0), the motor
will start immediately.
Multi-mixer operation
∙ Fit the blender jug to the motor housing,
with its handle to the right, in such a way
that the two triangle symbols are aligned.
∙ Put the liquid ingredients into the blender
jug. The jug has a maximum capacity of
1000 ml. To avoid possible foaming or
spilling when processing foamable or thin
liquids such as milk, do not fi ll the jug over
the 700 ml mark.